creating a silicone mould

by wickinc

This slideshow requires JavaScript.

here we did our first draft silicon mould.

we put a small amount of silicon on top of one of our acrylic masks to see if it could pick up the fine detail we created and it could which was great.

we are still waiting for the rest of the silicon to dry as it takes over night. but we will just do one half of the two part mould and put a stick stuck into the urethane and get the clamp to pull it out to see if there will be any problems pull the mask out of the mould, if it is too tricky for what ever reason the clamp  may end up pulling to firmly on the stick and derailing the conveyor belt so we need to test for this at the moment.

Advertisements